• Certificate No. KM658891. Product promoted and available only out of Europe • Maximum 2A @30V > FDMC404 4 input and 4 output module Same feautures of FDMC602 but with 4 inputs and 4 outputs. Available only out of Europe > FDMM422S 4 input 2 output 2 monitored output module Same feautures of FFDMC602 but…
Devamı
Volume must be setted on the siren. Sync with sirens group is available • Plastic red box • Insulator circuit on board • Power voltage: 19-30Vdc (per EN 54-3) • current : 70 μA • Current in alarm stae: 5-7mA (24V- line) • soun level: 80 – 100dB • Max delay to start: 2 sec…
Devamı
This type of detector (figure 1) continuously samples the air in the protected area to provide the earliest warning of fire and yet offers a high level of false alarm rejection. The digital communication protocol employed by the monitoring control panel provides high rates of information exchange in combination with comprehensive features that ensure fast…
Devamı
HARDWARE features • Addressable fire alarm panel with 32-bit microprocessor • LCD touchscreen display ( 480×272 TFT 4.3 “ ) • Back light on/off and three settable colors • 1 addressable loop, expandable up to 9 loops (with 4 One2) configurable as open or closed, • Digital protocol . • Frontal LEDs with three settable…
Devamı
Vigilon can accommodate a high quantity of loop powered interface units offering fexible range of inputs and outputs from the FD&A system from plant control and signalling other systems in a fi re, to linking with other emergency management systems such as sprinklers or security systems. Loop powered interfaces offer a cost effective solution with…
Devamı
Honeywell Gent’s low-current S-Cubed range incorporates a sounder, voice sounder and an EN54-23 certified visual alarm in one device. Advanced loop powered technology means that S-Cubed is the most efficient loop powered sounder in the industry where a whole loop of sounders could be powered without the need for additional power supplies. The S-Cubed range is…
Devamı
Manual call points for the Vigilon and Nano system are easy to install and may be mounted on standard installation back boxes or bespoke red back boxes for surface mounting. Every manual call point is continuously monitored ensuring a trigger is responded to in less than three seconds system wide. Every manual call point is…
Devamı
Honeywell Gent’s duct smoke sensor has been specifically designed for use in ventilation ducting. Mounted externally to the duct, the device uses venturi probe technology to sample the air for smoke. If smoke is detected, the device triggers the shut down of air-conditioning or ventilation systems to isolate the hazard and prevent it spreading. >…
Devamı
Honeywell Gent’s S-Quad Beam Sensors provides an enhanced solution for linear beam detection for applications where point detection is either not practical or economic. Powered and controlled via the loop, the beam is a market leading device with features such as ‘one man alignment and commissioning’ which is achieved using the auto gain setting, this…
Devamı
